Magellan ProMark3 RTK Specifications download pdf (Page 88)

6. Post-Processing Surveying

This chapter presents step-by-step procedures for performing

a GPS survey with the ProMark3 system. Review this chapter

thoroughly before attempting to perform your first survey. As

an exercise, take your system outside of your office and per

form a sample survey following the procedures outlined below.

Then download and process the collected data with GNSS So

lutions. After this exercise, you will be ready to perform your

first real survey with the ProMark3 system.

Introduction to Static Surveying

Prior to venturing out into the field, you must first plan how

you will execute your static survey. Proper planning will greatly

increase the chances of success. There are two primary areas

of static survey planning, the network design and observation

plan. Each is discussed below.

Network Design

You have identified a survey for which you wish to use the

ProMark3 system to establish control. Regardless if the num-

ber of control points to be established is 2 or 20, you must

design a network defining the number and location of obser-

vations (vectors in our case) that will be required to effectively

position the new points.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 291 292

No comments

Magellan ProMark3 RTK Specifications Page 88