Magellan ProMark3 RTK Specifications download pdf (Page 69)

Staking Out

It is assumed that the rover has already been RTK initialized.

1. Press the LOG key and then enter the following parame-

ters:

• Survey Mode: Select Stakeout.

• Antenna Height: Enter the height you measured in the

setup phase (see

page 41). ProMark3 RTK will save

and indefinitely use this value until you change it

manually.

• Units: Specify the unit that was used to measure the

antenna height (meters, US feet or Int feet).

• Height Type: Specify the type of measurement you

made (Slant or Vertical) to determine the antenna

height.

• Time on site (sec): Time, in seconds, that must elapse,

with the antenna not moving, before the rover stores

the position of the point (default: 15 seconds). You

decide the duration of the occupation (If it is greater

than 1

second, the position solutions will be averaged

over this period of time to improve accuracy. If it is

second, there is no position averaging but work pro-

ceeds more quickly).

• Enter coordinates manually check button: Do not check

this button if the points you want to stake out are con

trol points already stored in memory. Check it on if you

want to enter the coordinates for a point to stake out.

2. Tap the OK button. Depending on how you set the Enter

coordinates manually

check button, the receiver now dis-

plays the list of control points, so you can select one

(below left), or asks you to enter the coordinates of the

point to stake out (below right). In the latter case, make

sure the coordinate system used is the right one (MENU

key> Setup> Coord Sys).

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 291 292

No comments

Magellan ProMark3 RTK Specifications Page 69