Magellan ProMark3 RTK Specifications download pdf (Page 53)

Configuring the Base

1. Double-tap the Surveying icon.

2. Press MENU, tap Receiver Mode, then Real-Time.

3. Press MENU, tap Base Station and then enter the base

parameters:

• Station ID: Enter a 4-character string (0.. 4095) for an

unambiguous identification of this base.

• Height Type: Indicate the type of height (Slant or Verti-

cal) you measured while setting up the base ( see step

12 on page 38).

• Antenna Height: Enter the height you measured while

setting up the base (see step 12 on page 38).

• Units: Indicate the unit used to measure the antenna

height (meters, US feet or Int feet).

Depending on whether the base is installed over an

unknown or known point, do the following to enter the

base position:

Unknown:

• Tap on the right arrow next to the Site ID field. Select

Current Position from the list. This assigns the current

position computed by the ProMark3 RTK to the base

(see

Location and Elevation fields). Before making this

selection, make sure the ProMark3 RTK has deter-

mined the position (see Position screens on page 147)

and this position has been averaged for some time.

Note that the Site ID field is changed to ???? in this

case.

Known: Two possible scenarios:

• Base installed on a control point stored in the

ProMark3 RTK: Tap on the right arrow next to the Site

ID field. This opens a points list from which you can

select the control point name corresponding to where

the base is installed. Choose this point name. This

automatically sets the

Location and Elevation fields to

the right coordinates.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 291 292

No comments

Magellan ProMark3 RTK Specifications Page 53