Magellan ProMark3 RTK Specifications download pdf (Page 132)

118

Re-Initialization

When is Re-Initialization Required?

Re-initialization is required when the following message ap-

pears on the screen, due to poor GPS reception, while you are

running a Stop & Go or Kinematic survey that you initialized

through the “Bar” or “Known” initialization method:

When this occurs, you will unfortunately have to resume all or

part of your survey. The reason for this is that due to a break

in the flow of collected data, the post-processing software will

not be able to deliver the expected level of accuracy for all

those points that you might have surveyed AFTER the data

break.

Following the occurrence of this message, tap anywhere out-

side of the message window to acknowledge the Reinitialize

alarm. Then resume the survey from the last control point you

surveyed (see next section).

The next section describes a preventive procedure that you

can use to better respond to possible re-initialization require

ments.

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 291 292

No comments

Magellan ProMark3 RTK Specifications Page 132