Magellan ProMark3 RTK Specifications download pdf (Page 140)

126

3. Logging and Describing a Line Feature

Basically, you use the same procedure as when you log a

point feature (see 2. above). There are however two differ-

ences when you log a line feature:

- You need to define a logging interval when you start

logging the feature

- And then you are supposed to move from the begin-

ning to the end of the line feature before stopping the

logging.

These differences are explained below.

After tapping a line feature from the Feature List screen

(for example a road) and tapping the Log button,

ProMark3 starts logging GPS positions from the position

where you are. The default logging interval is 5 seconds.

By decreasing the logging interval you can increase the

level of detail in your maps. By increasing the logging

interval, you can save memory. In general, you should set

the logging interval to the smallest setting possible with-

out running out of memory. Remember you can take multi

ple SD cards with you to the field. The only requirement is

that you close the job file before replacing the SD card.

To change this interval:

- Tap Options on the screen and then Logging Interval.

Selecting the logging inter-

val option

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 291 292

No comments

Magellan ProMark3 RTK Specifications Page 140