Magellan ProMark3 RTK Specifications download pdf (Page 123)

109

Note that the content of the Site ID field is incremented by

1 after ending static occupation on a point (increment: 0

to 9, then A to Z, then 0.. again, etc.). You can however

change the Site ID between any two occupation times by

pressing the LOG key (not the on-screen LOG button) and

editing the Site ID field.

12.Move to the next point and resume the above two steps

until all the points have been visited.

13.Ta p Done after surveying the last point. This completes the

data collection phase.

Running a Kinematic Survey

Base Setup and Operation

The base is setup and operated in the same way as it is in

static surveys (see page 88). The only difference is the possi-

ble use of the initializer bar at the base station.

The base antenna should be centered and levelled above the

known point. To be able to use the initializer bar for initializa

tion, be sure to incorporate the bar as part of the base setup

as shown opposite. This bar gives an accurate baseline of 0.2

m (0.656 ft) for initialization.

Cross points indicate

where static occupations

take place.

The line indicates

continuous data

collection, from the first to

the last point.

0001

0002

0003

0004

00050006

0007

Rover

Allowing for kinematic

initialization using

Initializer bar at the base

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 291 292

No comments

Magellan ProMark3 RTK Specifications Page 123