Magellan ProMark3 RTK Specifications download pdf (Page 282)

268

Installing Optional Functions in FAST Survey

To purchase an optional FAST Survey function (Total Station

or GPS), first run FAST Survey, go to Equip> About Fast Sur-

vey>Change Registration and read the registration code on the

Product Registration screen.

Provide your registration code when ordering an optional func-

tion.

You will receive in return a Serial Number and a Change Key

specific to your FAST Survey license. Enter these two codes

on the same Product Registration screen to activate the func-

tion.

When enabled, the Total Station (TS) and GPS options make

more equipment available from the list of instruments in the

Equip tab >Instrument function, thus allowing you to use FAST

Survey with ProMark3 RTK connected to a third equipment.

Using Another Radio Model

For some reason, you may want to use another radio model. In

this case, because you need the special connector used on the

ProMark3 side, you should continue to use the Magellan Pow

er/Data cable and connect your radio to the other end of the

cable.

To use this cable, first disconnect it from the Magellan radio

modem. This is simply done by unscrewing the base of the

Magellan radio modem and then removing each of the cable

wires from the screw terminal block. The cable pinout is given

below.

Note that the settings of the serial line between

ProMark3 RTK and your radio cannot be changed. These set-

tings are as follows: 9600 Bd, no parity, 8 data bits, no stop

bit.

Wire Color Signal Name

White TX (Data)

Red +DC IN

[Braid] Ground

Yellow +5 V DC OUT

Blue RX (Data)

1 2 ... 277 278 279 280 281 282 283 284 285 286 287 ... 291 292

No comments

Magellan ProMark3 RTK Specifications Page 282