Magellan MG5000 User's Guide download pdf (Page 15)

Magellan / Spectra SP 13

To turn off StayD mode:

[OFF] + [CODE] + [OFF]  Off light on

Press the [

OFF] key followed by a valid code, then press the [OFF] key again within ten seconds. The StayD light

will turn off and the Off light will light up to confirm StayD deactivation. With StayD disabled, the system will

function as a standard security system.

To Change Arm Mode

(see Arming & Disarming on page 14)

To change the level of security - Stay to Sleep:

[SLEEP] for 2 sec. Delay  Sleep light on

Press and hold the [

SLEEP] key on any keypad. All zones which will be armed in Sleep mode go into exit delay,

allowing you to move to the bedroom. When the exit delay ends, and you are in the bedroom, the rest of the

interior will arm. The system is now in Sleep mode.

To change the level of security - Sleep to Stay:

[STAY] for 2 sec.  Stay light on

Press and hold the [

STAY] key on the keypad located in the bedroom. The system will instantly switch from

Sleep to Stay mode, allowing you to leave the bedroom and move freely inside the house. If you accidentally

leave the bedroom without switching to Stay mode, all zones armed in Sleep mode will go into a delay, allowing

you enough time to switch to Stay mode.

Leaving the site - Stay to Full:

Keypad: [ARM] for 2 sec. Delay  Arm light on

Press and hold the [

ARM] key on the keypad that the exit path is assigned to. This will start an exit delay period

for all zones in the exit path. After you have left the property, all exit path zones will rearm. The system is now in

Full mode.

Entering the site - Full to Stay:

Keypad: [CODE] Stay light on

When entering the property through the entry path, all zones assigned to the entry path will go into delay,

allowing you to enter the house. Entering a valid code on the keypad the entry path is assigned to ends the entry

delay and switches the system to Stay Arm mode. The entry path zones will rearm. The system is now in Stay

mode.

Leaving the site without changing arm mode:

[OFF] for 2 sec.

Press and hold the [

OFF] key for 2 seconds on a keypad to leave the site without changing arm mode.

Advanced StayD Settings

Window Mode and Re-arm Delay

In a Stay-armed system: This mode allows you to open one exterior zone without triggering an alarm. To enter

Window mode, press [

OFF], then your [USER CODE]. All zones that can be opened flash. The system will start an

exit delay, allowing you to open an exterior zone such as a window or a door. The system will only allow you to

open one zone as the exit delay will end after doing so. When you close the open zone (window, door, etc.) that

zone will re-arm.

When closing an exterior zone such as a window or door, a delay will start allowing you to close the zone

properly. The re-arm delay starts when you close the zone, and you must keep the zone closed for the entire

delay period for it to re-arm. This is especially useful for windows that stick thus reducing false alarms.

Live View Mode:

During an alarm, press the [CLEAR] key to view the movement. The zone lights on the keypad will show the

opening and closing of zones as they occur.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Comments to this Manuals

No comments

Magellan MG5000 User's Guide Page 15

Comments to this Manuals

Related products and manuals for Security access control systems Magellan MG5000