10
7 -open-(cts)
8 -open- (tx+)
9 -open- (tx1)
10 Red (+12 to PM3) (rx+ used as placeholder)
11 (right) -open- (rx-)
Pins 2 and 3 are electrically connected on the PCB. Pin 10 is only used as a
holding location for the Red wire. The Red wire connects to the charging input
on the ProMark 3 receiver.
The D-shaped connector that is used to connect the radio modem to the
PM3 has these pin assignments:
(Note that this radio cable which is shipped with the radio is completely different
than the serial cable #730523 which is available as an accessory, PN 730523 has
different color coding and does not have the +5V regulated supply connection.)
Modifications
This picture shows the modem terminals with the bypass capacitor after
modifications:
Comments to this Manuals